It is important to check that your probe is correctly calibrated using PROBE_CALIBRATE. Note that unlike other Voron models, the Switchwire uses the probe as a virtual endstop, and thus should NOT use relative_reference_index. However, if you do wish to fine tune it, detailed information can be found in the Klipper docs. The mesh settings in the stock configs are usually fine. It’s more difficult to get a good reading, but easier to interpret the result.ĭue to the the use of a thinner bed on the switchwire, a bed mesh is usually needed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |